|
| |
Training Requirements for BreathScanŽ
blood alcohol testing
Buy BreathScan
blood alcohol testing kits
- As each person is
blowing into their tester, have them verify the test is being performed
properly by listening to the air passing through both their tester and their
partner's tester for the blood/breath alcohol testing kit.
- Have each person
compare the used tester with an unused tester, so that they can see that the
crystals are still yellow in color--some of the luster is gone, but the
color is still yellow.
- Using a mouthwash
containing 26.9% alcohol or higher (i.e., Scope or Listerine), and plastic
cups containing a small amount of mouthwash to each person. Instruct each
person to swish the mouthwash in their mouth. They may spit the mouthwash
out into the cup if they desire. Following the instructions in 4, above,
again, have each person blow into an unused tester immediately after rinsing
their mouth out with alcohol. Shake tester to distribute crystals evenly in
viewing window. Lay tester flat on a flat surface, and wait 2 minutes. The
yellow crystal color will disappear when the alcohol level is at or above
.02. The .02 testers' initial color is very light yellow. The .02 will
become white or ash at an alcohol level of .02 or
greater. What the administrator is looking for is this color change. For
best interpretation compare crystal colors to those of an unused tester.
- Each trainee should
have blown through two testers one without alcohol first on their breath and
one with alcohol (mouthwash) on their breath. The administrator should have
each trainee demonstrate that they can successfully "read" the
tester and correctly interpret the result for blood alcohol testing.
Previous
Buy BreathScan
blood alcohol testing kits
Goto Alcohol Breathalyzer, Breath Test & Analyzer Kits @Home
blood alcohol testing